After installing high idle switch as per Kennedy's instructions and making sure it worked properly, I proceeded with ODLO.
No problem very easy, checked and rechecked pins and connector. When I tested ODLO nothing happened. No light and when I went for a test drive no lockout. Disconnected batteries again pulled TCM and check pins again. Then tested switch and wires for continuity. Everthing seems OK. Went over instructions again. Pin C1-28 and C1-12 for switch and C1-20 for LED W/resistor.
Any ideas or help would be greatly appreciated.
One other question: Is the C1 plug below the C2? Both my plugs were gray. One with a clear cover (C1) and one with a red cover (C2). In Kennedy's instructions C2 plug is red with a red cover.