Enthusiast
Anyone have suggestions for a shroud for my 72 suburban 6.5 Turbo? I am running (in but not running) a 21 inch duramax fan/clutch, I thought it would work with my stock shroud...it doesn't.
It is a custom install in a 1972 Chevy Suburban!
[ 01-06-2006, 10:00 AM: Message edited by: tankbulldog ]
Is that right, a 72 Suburban with a 6.5? did you mean a 92?
If you meant a 92, I believe it just needs some trimming. I'm running the duramax fan in my 96. It was close, but required no trimming.
Enthusiast
Put the Dmax fan in my 94'. Had to trim the bottom corners a bit, no harm no foul, suck the shirt right off ya. I can't even get this thing to run hot anymore, between the cooling modes, new clutch and Dmax fan.
Bbudus
94' GMC K2500HD, Heath chip, -1.94, Turbo-Master, AFE Cold Air Intake, Bosch High Flow Injectors, 3" Exhaust all the way back, 4.5" chrome tip(exhaust sounds sweet), Heath Turbo Down Pipe, Heath Crossover, IssPro gauges, Three Pod Piller, 98' Cooling Mods, DMax Fan, High output water pump, DSG Oil Cooler, Heath PMD kit, Light kit with high output bulbs(very bright...finally)
Posting Permissions
