If it'll clear .010" on all journals, I see nothing wrong with grinding the crank. There is still enough of the hardening on the surface after a .010" (just .005" on each side).
Just need a machine shop that understands staying out of the rolled fillets.
Been beating on a .010/.010 crank for years now in my drag truck...
1982 C10 SCSWB 6.5TD, mods too extensive to list. (13.69 1/4 mile @94.6 MPH) RACE TRUCK
1982 C10 SCSWB 6.2NA, 2.73 700
1986 C10 SCLWB 6.2TD 3.73 700
1989 V20 SUB 6.2NA, 3.73 400
1994 G20 VAN 6.5NA, 3.42 60E
1994 K20LD ECSWB 6.5TD, 3.42 80E
1995 K20 SUB 6.5TD, Wrecked, ran into by stupid teen.
1995 C3500HD DRW 6.5TD, 12' Flatbed 5.13 80E
1995 C3500HD DRW 6.5TD, 18' Rollback Wrecker 4.63 80E
1994 C20HD ECLWB 6.5TD 3.73 80E Wifes Truck.
1995 C20LD ECSWB 6.5TD 3.73 80E
1995 K20LD SCLWB 6.5TD 3.73 80E
1996 K30 DRW 6.5TD 4.10 80E
1997 C10 Tahoe 2Door 2WD 5.7L to 6.5 Conversion Underway