I was poking around on the driver side finishing attaching the power steering line supports when i saw this:

https://goo.gl/photos/vs1BbabamzQgm3gWA

Thank god I noticed...

I pressed in a new moog ball joint a couple months back... I'm pretty sure it looked fine a week ago.

The ball joint is destroyed, the boot is literally shredded and shoved halfway through the control arm.

The control arm splines are deformed.

I'm going to blame myself, I pushed it in, I have never done it before and likely screwed it up.

Just wondering if anyone has insight for me? I'm also now worried because I did the other 3 ball joints... They still seem solid, I went down and checked each of them. Also, by the time I got to them I was a little more competent at being able to line them up properly. Has anyone else seen this?

Thanks!

I've purchased a new MOOG control arm and will install it tomorrow.