D-Max Intercooler size?

[AndyL]

Looking to size my custom 6.5 IC, figure the D-Max setup would be more than adequate.

Anyone have dimensions and tube layout?

[More Power]

The IC core is about 36" wide and about 16" tall. I could be a little off in the height. It's been a while since I measured one.....

This Dmax core is very close in size to what Dodge uses in their 1994-2002 Cummins equipped trucks. Both are manufactured by Behr. The Dodge IC uses 4" inlet/outlet, where GM uses 3".

Dodge IC's are less expensive because there are so many more of them available on the salvage market. Ebay usually has a couple auctions going at any given time. Just search for "Dodge Intercooler". A modified Dodge intercooler is what resides behind the grille of the current Project truck.

MP

[AndyL]

Thanks,is it about 1.5" thick with a 1" core tube?

I have been eye-balling a 24"x12"x3" on Ebay for a while. The ad claims 900 CFM, they don't list a pressure drop.

Check out the interesting tube design.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=2479700751&category=33742

[More Power]

The following link will show you what dimensions I have for the Dodge IC.

http://www.thedieselpage.com/members/duramax/project2-ic.htm

I don't remember how many rows of tubes there are. However, I do remember that the inside of each tube contain fins like what is on the outside.

MP