bleeding fuel filter

[Phil Garrity]

I need to know how to activate the lift pump on my new 95 blazer to bleed the line and filter. My 94 is easy by removing the lift pump fuse and applying 12 volts to the wire. The 95 though is different. Thanks

[Phil Holmen]

Put the truck into gear and turn the key all the way to start, the pump will then be running...
If you plan on adding the OPS relay simply add a push button switch to overide the relay.. This is what I have done. I also added a small LED light to show when the relay is engaged.

[HowieE]

You can run the lift pump directly by applying voltage to the gray wire, circuit 120, terminal B in connector C103 located in the engine compartment under the master cylinder.