PDA

View Full Version : First Time Oil Analysis



stingthieves
08-21-2006, 07:15
Some may have noticed I recently posted that I replaced my stock oil and trans coolers with HB7

jspringator
08-21-2006, 15:19
There is no way to know unless you have it tested. I arbitrarily chose 6,000 miles with my Amsoil DBOF and synthetic Rotella. Filter fittings sprung a leak, and I calculated it was cheaper to change the oil every 3,000 miles rather than buy the special filters. I like to test periodically to check for glycol and salt (coolant in oil) and Silica, which indicates leaky air filter, and fuel, which indicates a stuck injector. My soot was never high with my DBOF setup. The TBN or total base number is the condition of the additive package; the standard measure of when it is time to change the oil. I don't know if it depletes linerally, or gives up the ghost all at once.

The extended drain concept makes a lot more since on an engine that uses 16 quarts of oil. Ours use so little, it doesn't save enough money to pay the extra for the expensive filters.

HH
08-22-2006, 07:14
I would sample every 5000 - 6000 miles plus or minus to give you a base. Once you know your extended drain interval you can sample at 12,500 plus or minus.

As far as using a synthetic, even if you do not use a bypass filter, one can save money and time.

Averaging 25,000 miles per year.

Sythentic costs - 8 quarts = $52.00
- 2 Filters = $32.00
- 1 quart for filter change = 6.50
- 1 oil sample analysis = $20.50
- Total Cost = $111.00

Dino Oil - 8 quarts = $20.00
- 1 filter = $6.00
- Total = $26.00 for one oil change
- every 5k /5 oil changes in 25,000 mile = $130.00, plus time to do it.
- every 4k /6 oil changes in 25,000 mile = $156.00, plus time
- every 3k /8 oil changes in 25,000 mile = $208.00, plus time
- add an analysis so you know your engine condition +$20.50

stingthieves
08-23-2006, 13:23
Wow
And I though I was working out the numbers
Thats great!
Thank-you

More Power
08-23-2006, 17:03
There's an article in the Member 6.2/6.5 Archive (linked in sig) about "Engine Oil Analysis" that explains what to look for. :)

Jim