dieseldummy
04-26-2007, 22:45
Ever tried to pull a valve cover or oil pan after using The Right Suff gasket maker on it? What a biatch! I can honestly say that I've got a junk valve cover because of it... It can't be tapped loose with a rubber mallet like with most gasket sealents. It has to be cut with a putty knife to loosen the two surfaces.
Basicly it makes working on the engine in chassis nearly impossible... As if pulling a valve cover or pan in chassis isn't hard enough. I'm throwing this out there as a warning: If you ever think you may pull the tin off the motor don't use the Right Stuff. If you plan on never touching the engine and want a good leak free seal then The Right Stuff is the "stuff" to use.
That's just my little informational lesson for the evening. I have heard that rare cases of "right stuff rage" have caused people to loose their minds... I'm not the only one either.:o Didn't want the same thing to happen to unsuspecting souls.;)
Basicly it makes working on the engine in chassis nearly impossible... As if pulling a valve cover or pan in chassis isn't hard enough. I'm throwing this out there as a warning: If you ever think you may pull the tin off the motor don't use the Right Stuff. If you plan on never touching the engine and want a good leak free seal then The Right Stuff is the "stuff" to use.
That's just my little informational lesson for the evening. I have heard that rare cases of "right stuff rage" have caused people to loose their minds... I'm not the only one either.:o Didn't want the same thing to happen to unsuspecting souls.;)