Front Suspension leveling kit

[Joshthemule]

Does anyone have experience with these. It looks like a new adjustment arm for the torsion bar. I just wonder how well it works. Anyone?

[More Power]

Just my opinion, but I don't think raising the front of the truck (beyond stock) using the torsion bars is a good way to go. The geometry of the ball joints, tie rods and front CV drive axles are all engineered to operate within defined angle limits. Raising the front changes the angles. More bump steer, more toe-in/toe-out variations as the suspension flexes and shorter component life usually occur after raising the front of an IFS truck.

Jim

[96ccdd]

For now I just cranked the bars up but I also put less than 10k a year on my truck. When I get ready to replace the tire I'm going with http://www.cognitomotorsports.com/ . But a guy I work with is going to use this http://www.suspensionmaxx.com/ .

[rickstrk]

I have a heavy(250+) front bumper:D and after a year and 20k+ I decided that I needed 3 turns on the torsion bar adjustment. 10K+ later I notices I was getting cupping. Turned it back down 2 turns and will just live with the low:mad: ground clearance. Rick