Log in

View Full Version : chevy truck parts 73-87



350Tacozilla
08-07-2009, 06:45
ok got 2 sm-465 and np 205 combos

one with hydro clutch bought from local guy never used it myself said has noise but its not bad transfer case is modded for twin stick $200

one with linkage style clutch $200 no noises at all, transfer case is also in great shape no problems

spare np 205 coarse spline for manual $50

pair of doors in good shape $100takes them good glass and mirrors

lund sunvisor $40 (73-87 or 73-91 blazer/sub)

1 set of BBC headers for 73-87 4wd chevy truck were on truck for less than a week $75

1set of SBC headers for same truck little older but not rusted out $40

I also still ahve spare cab with good windshield and back window...4spd truck with good floors take $100 with or without frame

I have a 3/4T 4x4 chevy I am selling axles, transmisssion and transfer case out of

AXLES-- $800 obo
1976
front--dana44 HD front 8 lug with 3.73 gears and the large dana 60 style hubs
rear-- GM corp. 14bolt full float with 3.73 gears and factory gov lock locker


1988
Transmission and transfer case are 700R4 and np208 transfer case -- $350

removed from truck running and driving

also may sell motor it is a 1988 350TBI with 39,000 original miles would be looking to get $500 obo from it.... if you buy more than one thing I will give you a good deal


also have a spare 14 bolt srw that has 4.56 gears (i believe) was taken from running driving truck about 2 years ago... has gov lock might be 4.11

I also have few fenders laying around for 73-80 trucks along with a hood or two.. if you dont see something listed you are after just ask I might have it

350Tacozilla
08-11-2009, 08:13
just got a 1984 gmc 2500 that I am pulling motor from its a 4spd truck with dual shocks up front, body isnt in good shape lots of dents, rust etc..bed floor is solid and truck still runs and drives as of right now $700 for the rolling chassis,body trans/transfer case,driveshafts etc