gophergunner
04-10-2011, 20:49
I'm working on a project at home and I'm come to a slight issue with my front drive shaft and the 700R4 pan.
I don't have much room between the two parts, the area in trouble is the right, rear of the transmission (passenger side if you will).
I'm wondering if I can trim and modify my pan for another 1" of clearance?
I'm not well versed in the internals/workings of the 700R4 but based on what I can see on the outside I'm not thinking I can do this.
I'm also going to get a smaller diameter driveshaft when I get one made, but if thats not enough I might have to limit suspension travel a bit.
Any advice would be appreciated. Thanks in advance!
Here's a picture for reference.
http://i50.photobucket.com/albums/f350/gophergunner/IMG_0888.jpg
I don't have much room between the two parts, the area in trouble is the right, rear of the transmission (passenger side if you will).
I'm wondering if I can trim and modify my pan for another 1" of clearance?
I'm not well versed in the internals/workings of the 700R4 but based on what I can see on the outside I'm not thinking I can do this.
I'm also going to get a smaller diameter driveshaft when I get one made, but if thats not enough I might have to limit suspension travel a bit.
Any advice would be appreciated. Thanks in advance!
Here's a picture for reference.
http://i50.photobucket.com/albums/f350/gophergunner/IMG_0888.jpg