DCT 19 crankshaft position reference error

[wjm]

1994 6.5tb diesel Have a problem with code 19.

Been a gas mechanic for 50 some years and am lost on diesel. Need some help on this code 19, where to start! What can I do not having a tech tool to analysis this problem? Have noticed no difference in the running or performance. What problems can I expect in the future? Any help would be welcomed.

1994 6.5 diesel, gear driven camshaft, 97 two thermostat water system, banks exhaust, egt and boost gauges, fsd cooler

[Cowracer]

Crank position sensor. Directly aft of the crank snout on the drivers side of the block. Its a round sensor with a metal tab, one bolt holds in through the tab, and a cord. Check to make sure the connection is good, but you might have to replace it.

They are absoluty a B!TCH to remove. The tab breaks off at the slightest tug. I had to drill a blind hole in the middle of it and screw in a large deck screw to get something to grab onto with a small pry tool to get it out.

Should cost about $75 bucks for a new one.