PDA

View Full Version : 6.2 ???



odee
08-16-2003, 05:55
On the way back from the dropping a 6.5 block and crank off at the machine shop I ran across another 6.2 that is running this is a red engine from a 82 model half ton. Is it ok to swap my j series intake over on it? What about swapping the later style rocker shafts or just run it the way it is? Thanks

britannic
08-16-2003, 09:28
Your intake will bolt on just fine; definitely fit the new rocker shafts if you can, as insurance against potentially spinning the old style bearings and subsequent rocker shaft failure.

odee
08-17-2003, 03:34
thanks, I've also got the timing set from the 97-8 model 6.5 that cracked the cylinder walls will it work also?

odee
08-18-2003, 21:43
Can someone offer some input on the timing chain issue? Would the one from the 98 engine work on the 82 one. I have just started swapping the rocker shafts out for the later style. Got the j intake out and cleaned up to go on also. thanks

CleviteKid
08-18-2003, 22:37
The timimg set from the new 6.5 is not a direct swap because of the reluctor for the electronic injection. If you cannot afford a gear drive right now, a good quality chain set will be about $60, and is money well spent.

Dr. Lee :cool: