Hi, Robyn. I was following the shop manual and also found these instructions online:
The rotating instructions are the same
??????
Why are you wanting 30 degrees
Put the push rods in the correct way with the marked end up to the rockers.
Bolt the rocker shafts
Hi, all. I'm about to put the rocker arms back in and need to get the engine to about 30* BTDC. I've got a Fluidampr and am wondering what reference on
malpana 05-31-2025, 18:30We went on a pretty tough towing excursion over the past couple of days - (20' enclosed trailer was an estimated 10K parachute). I was curious whether
More Power 05-29-2025, 11:07
Rings and bearings while I have the engine out?
The material you found is good advice.
Robyn Today, 06:14I usually placed all the pistons so they were in the hole a bit before bolting the heads on.