Those cups are very hard. I don't think I'd go too easy on them. I've had to clean up burrs on the skirts a time or to, and I think they were harder than
Yeah, I thought they looked a little off... I might try running a deburring tool lightly over the edges that need it. 6 out of 8 of mine from the engine
The only concern, I think, would be flow characteristics. I don't see that smoothing edges of the opening would change that any, or enough to really matter.
Hey everyone, I just recently acquired a new set of 6.2 3 dot Inconel precups. After the initial magnet test and thorough inspection I noticed the edges
Sections
Categories (Show All)
Recent Articles
Recent Article Comments Widget
Preventing precup cracks, or dumb idea?
Those cups are very hard. I don't think I'd go too easy on them. I've had to clean up burrs on the skirts a time or to, and I think they were harder than
DmaxMaverick Yesterday, 18:08