Results 1 to 5 of 5

Thread: Six of eight Glow Plugs

  1. #1
    Join Date
    Jun 2000
    Posts
    124

    Default Six of eight Glow Plugs

    Hello All:

    I have only six out of eight glow plugs that glow. The last two were just too hard to get at. Other than a bit harder starting and lots of white smoke on startup, will this do any damage?

    1997, 2500 Subway, 4X4

    Thank you, Wayne

  2. #2
    Join Date
    Nov 2003
    Location
    Sun City AZ
    Posts
    695

    Default which 2 are left?

    If it's #8 - rear passanger - I got to that one from underneath - really easy to do.

    If it's #6 - well the dang down pipe... and #4 , once you undo the "Heat shield Tube", isn't that bad -

    Oh to answer your question- I don't think so...
    OOps sold my "baby" - 96 K-2500 6.5TD - ~047,068mi, Isspro's Boost, Pyro, and Tranny temp; Heath Plate Remote mounted FSD; Amsoil Fluids and Air; Bilsteins, BD Down Pipe-Gutted CAT-& B-D'ized 3.5 Kennedy exhaust; '97 cooling upgrade; CAD upgrade; new IP at 34,700 under warranty; Homemade: Boost fooler, Hi/Lo idle, OPS relay, TCC Lockup ( TFT), Glow extender for AC60's, & "GMC H..'s" 6 position Shift modifier .

  3. #3
    Join Date
    Sep 2001
    Location
    Lubbock TX, USA
    Posts
    4,194

    Default

    It's not good for the engine to start on some and not others.

    IMHO, this uneven firing may place undue stress on the crank and webs below.

    Aftermarket downpipes make changing #6 and #4 almost impossible w/o removing either the turbo or the downpipe itself.

    J

  4. #4
    Join Date
    Mar 2000
    Location
    Windham, ME
    Posts
    2,490

    Default

    The only one I found moderately difficult on my 6.5l was the #6. With a good ability to navigate my touch and sense of "it oughta be...there!" you should be able to reach it with a 1/4" drive ratchet, 6" or longer extension, and 3/8" (AC60G) or 10mm (Kennedy) deep socket.
    Phil

    '90 Jeep Wrangler, 4.2l, AX15, Dana 30 & 35 with 3.07s (for now!) 4" Rough Country lift, 33x10.5x15 BFG KM2s

    '91 F350 XLT Lariat crew cab, 2WD SRW, 7.3l IDI, ZF S5-42, 3.55 LSD.

  5. #5
    Join Date
    Mar 2001
    Location
    Mission B.C. Canada
    Posts
    1,814

    Talking

    LOL I drilled a hole though the inner fender well just for #6 ( :
    Original D.P. Member #750, 2009 Ext Cab LB 4x4 Duramax/Allison, Black, Linex, 1993 6.5 TD 4x4 reg cab LB, 5 speed, 1972 Pontiac Lemans, 94 cady De Ville

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •