Both my upper ball joints are shot. I ordered new Moogs and they should be here tomorrow. They were only $67 shipped to my door from Express Auto Parts. The alignment shop wanted about $250 to install both ball joints. I know the OEM's are riveted in, and that's not a problem as I have air tools. I have a wide tie rod fork that should work to drive them out of the taper and an aceteline torch if they need a little persuasion. Are there any other tools I need? I saw in a search some said they wished they had a ball joint press. What is that? I've never heard of one before. Do I need one? Any other advice and tips are welcome.