Water pump? or Lower Radiator Hose?

[rapidoxidationman]

https://drive.google.com/file/d/1GOl...ew?usp=sharing

There we go.
You can see the weep hole in the center, and I suspect that if it was indeed a bad seal my Q-tip would've come out of the hole with some orange on it. But it didn't.

[DmaxMaverick]

Doesn't sound too complicated. Weep hole is dry, but lower coolant hose isn't. Go with your second suspicion. If it were leaking from the WP weep hole, it wouldn't not leak (or show signs of it) when you're looking at it. The black "grime" is a good indicator that coolant hasn't passed through there in a while, and that much coolant loss in a day is a lot. Time to replace the pressure cap, as well. You're probably getting out of this one easy. A pressure test is never a bad idea, in any case.

[DieselDavy]

Concur with DMax. Lower Radiator Hose, clamps and Radiator Cap, done!
You are one lucky man!
Dave
PS. Let's not talk about the other nasty things it could be right now. I'd just go for the low hanging fruit and see if that takes care of it.

[More Power]

Any signs of black smudging inside the coolant surge tank?

[rapidoxidationman]

Pressure testers. Saving shadetree mechanics from shotgunning parts since this morning.
There's a cooling line that runs under the turbo intercooler line on the driver's side that has a fair sized blowout in it. You can see a stream of coolant spewing forth in the pic attached. Now to dig down to it and find the replacement part...

https://drive.google.com/file/d/15_-...ew?usp=sharing

If anyone knows what the part is called, I'm all ears. I'll be searching my alldatadiy account.

[rapidoxidationman]

A closer look makes me think I just need to replace a short chunk of small diameter heater hose. Crossing my fingers that this'll prove to be a cheap (!!!) repair.

[rapidoxidationman]

Replaced the 5" piece of 3/8" heater hose that is the flexible part of the coolant return line from the turbocharger, put the cooling system back together, filled it up, and put the pressure tester on it. Pumped it to just under the cap pop pressure of 15#, and it seems like it's holding. Now it's lunchtime.

[jbplock]

Rapid,
After reading about your experience with the Turbo coolant line hose I'm thinking a preventative maintenance action might be to change them on my 03 LB7 - one near the water pump and one at the turbo. It wouldn't be fun to have one fail when towing my 5th wheel on a hot day. And I might as well replace the other hoses too. Back in the day it was common practice to replace hoses periodically to prevent failures. I was curious why modern hoses seem to last much longer and found the following info in the following Consumer Reports Article.

https://www.consumerreports.org/car-...lts-and-hoses/

“Experts recommend, however, that all hoses be replaced at least every four years or when one fails. Always use replacement hoses designed to fight ECD. Trademarks will vary among hose manufacturers. (Gates uses "ECR" for Electro-Chemical Resistant). Look for a "Type EC" label on the hose or its packaging. That is a Society of Automotive Engineers standard signifying "electrochemical." Most vehicles built after 1993 come with ECD-resistant hoses.”

And here’s another link with more detail on ECD

http://www.highwaystars.net/blog/wha...radation-mean/

Anyone have thoughts on replacing hoses as a preventative maintenance action?