Well had to change mine this weekend. My hands are just a little to big for the space allowed. Was easy to get electrical lead off, but the next time it won't be as easy. New one cinched down 180 degrees off from the original so the release tap is up now instead of down where you can see it.

The trick I found was to place a jack under the bell housing and was able to lift engine trans about 1/4 in to get just enough room to reach in and get the new one started. I tried a piece of fuel hose in the end of it like I have done with deep recessed spark plugs but it just wouldn't work.

Hope this helps someone else out down the line.