Enthusiast
The new vacuum pump that I just received did not come with the gasket that fits between the shaft of the pod and the engine.
Does anyone have a part number for this gasket (I have never even seen it, I do not know if it is an o-ring or flat gasket). Can I just use RTV to make a new gasket
1985 K20 Suburban 4X4 <a href=\"http://www.karensphotos.com/suburban\" target=\"_blank\">www.karensphotos.com/suburban</a><br />6.2L \"J\" code<br />TH400 3-speed Auto<br />3.73 rear
Me, too. I just cut one out of gasket material and seems to have worked now for 2 years. I don't understand why they don't include one. Anybody know something better?
Enthusiast
I beleive there is supposed to be an O-ring that fits between the pump shafthousing and the block in the angeled side off the hole in the block.
I have to check to be sure but RTV or O-ring will both hold the oil in and the dirt out.
Peter
'85 CUCV blazer 6.2 twin turbo diesel (300 HP ), 4L80E with PCS trans controller '64 F350 tow truck (restoration project)
Enthusiast
The part number for the gasket is-14022649
Enthusiast
Thanks all!
1985 K20 Suburban 4X4 <a href=\"http://www.karensphotos.com/suburban\" target=\"_blank\">www.karensphotos.com/suburban</a><br />6.2L \"J\" code<br />TH400 3-speed Auto<br />3.73 rear
Posting Permissions
