I recently removed the juice and installed the tech iv programmer from PPE. The next day I got the light "check engine oil level" I shut her down and checked the oil, all was well. Only 1500 miles on 15w40. I disconnected the batteries for a bit, hooked them back up and was fine for a few hours, then got the light again. This time I did an oil change and filter change (dual bypass system), to rule out possible pluged filter or god knows what. Disconnected the batteries again to reset code. Got the light again. Good oil pressure, doesn't seem to matter cold or warm. I have a call into PPE to see if anyone else has had the problem and will hear back in an hour. I am leaning towards a bad sensor. Anybody know where that would be located? Anybody had that light before? Suggestions? Thanks