Keep the Torque Converter Locked full Throttle (6.2L)
Ok,
Thinking out loud and I'm looking for some solutions either electronic or not for a test.
Engine platform: 6.2L
Transmission TH700R4 Electric Lockup Converter (fac config).
The typical configuration of the 700 Allows the torque convertor to unlock under full throttle during a shift down event.
I'd like a way to force the Torque converter to lock ONLY under full throttle, or by a switch on demand.
So, basically the opposite of the factory setup, but I don't want a switch to have to remember to flip, and then back off.
Any ideas?
Thanks!
J
1982 C10 SCSWB 6.5TD, mods too extensive to list. (13.69 1/4 mile @94.6 MPH) RACE TRUCK
1982 C10 SCSWB 6.2NA, 2.73 700
1986 C10 SCLWB 6.2TD 3.73 700
1989 V20 SUB 6.2NA, 3.73 400
1994 G20 VAN 6.5NA, 3.42 60E
1994 K20LD ECSWB 6.5TD, 3.42 80E
1995 K20 SUB 6.5TD, Wrecked, ran into by stupid teen.
1995 C3500HD DRW 6.5TD, 12' Flatbed 5.13 80E
1995 C3500HD DRW 6.5TD, 18' Rollback Wrecker 4.63 80E
1994 C20HD ECLWB 6.5TD 3.73 80E Wifes Truck.
1995 C20LD ECSWB 6.5TD 3.73 80E
1995 K20LD SCLWB 6.5TD 3.73 80E
1996 K30 DRW 6.5TD 4.10 80E
1997 C10 Tahoe 2Door 2WD 5.7L to 6.5 Conversion Underway